0-727-83 24V Durite Voltage Sensitive Relay for Charge Splitting

 Durite 24Vdc 140A voltage-sensitive relay (VSR) for vehicle charge splitting. When installed between the start and secondary 24Vdc batteries, the high load intelligent voltage sensitive unit is an efficient way of charging a secondary battery whilst not affecting the charging, depletion or performance of the primary start battery.

• Rated: 24 Volts DC, 140 Amps maximum load.
• With a Red LED indicator.
• Two M6 battery connection studs.
• The VSR makes (or cuts-in) at 27.4V and breaks (or cuts-out) at 25.6V.
• The M6 post next to the ground (-) cable is the Start Battery Positive (+) connection, and the opposite side M6 terminal is the Auxiliary Battery Positive (+) connection.
• CE approved.
• Pack Quantity: 1 piece.

Dimensions

• Length: 68mm.
• Width: 54mm.
• Height: 68mm.

About The VSR Unit

 Our VSR is a safe, reliable, and CE-approved way to split charge your second battery bank without the risk of discharging the primary or start battery. It automatically shuts off if the voltage drops below 25.6V, with a 5-second delay, to prevent any nuisance cut-outs due to high intermittent loads on the battery. With its 140 Amps maximum load, two M6 studs, and a Red LED indicator, you can be assured of efficient and reliable intelligent switching delivery. Plus, with our easy-to-install self-tapping screws and ring crimp terminal for ground lead, setting up your VSR is a breeze.

 The terminals (not supplied) for post connection must be for M6 studs, and the cable requires a large enough cross-section for the alternator's maximum output (charging source). Cable entry is facilitated by cutting suitably sized holes in the side(s) of the relay, and there are thinned-out sections in the casing to make this easier.

Specifications