0-294-20 Durite 12V-24Vdc Slim LED Combination Rear Lamp

 Durite 12V-24Vdc slim LED combination rear lamp with 6 x 0.5W Red LEDs.

• 6 x 0.5W Red LEDs.
• Protected to IP69K.
• E-Marked R10, R148, UKCA and CE.

Wire Colours

• Red: STOP
• Black: GROUND
• White: Tail

Dimensions

• Length: 130mm.
• Width: 30mm.
• Depth: 11mm.

Warnings for Translation Purposes

 Before using this unit, please read these instructions carefully. Take special care to follow the warnings and safety suggestions listed below. Keep these instructions for future reference. There are no user-serviceable parts within the unit; refer servicing to qualified service personnel.

Precautions

1. Proper installation of this product requires the installer to have a good understanding of automotive electronics, systems and procedures.
2. If mounting this product requires drilling holes, the installer MUST be sure that the drilling process could damage no vehicle components or other vital parts. Check both sides of the mounting surface before drilling begins. Also, de-burr the holes and remove any metal shards or remnants.
3. Do not install this product or route any wires in the deployment area of your airbag. Equipment mounted or located in the airbag deployment area will damage or reduce the airbag's effectiveness or become a projectile that could cause serious personal injury or death. Refer to your vehicle owner's manual for the airbag deployment area. The user/Installer assumes full responsibility for determining the proper mounting location based on providing ultimate safety to all passengers inside the vehicle.
4. Do not attempt to activate or control this device in a hazardous driving situation.
5. This product contains either strobe light(s), halogen light(s), high-intensity LEDs or a combination of these lights. Do not stare directly into these lights. Momentary blindness and/or eye damage could result.6. Use only soap and water to clean the outer lens. The use of other chemicals could result in pre-mature lens cracking (crazing) and discolouration. Lenses in this condition have significantly reduced effectiveness. Inspect and operate this product regularly to confirm its proper operation and mounting condition.
6. It is recommended that these instructions be stored in a safe place and referred to when performing maintenance and/or reinstallation of this product.
7. A good electrical connection to the chassis ground must be made for this product to operate at optimum efficiency. The recommended procedure requires the product ground wire to be connected directly to the NEGATIVE (-) battery post.

Mounting

1. Place the unit against the mounting surface.2. Mark the areas where the mounting holes will be drilled. Confirm that the drilling process could damage no vehicle parts.
2. Using a bit size for a no. 304 metal screw, drill two mounting holes, a 0.5" diameter. Wire passage hole(s) must also be drilled. Thoroughly de-burr all hole(s).
3. Pass the wires through the hole(s) in the gasket and through the wire passage hole(s) in the mounting surface. Fix the light head to the mounting surface.

Specifications