0-775-55 Durite 12Vdc Infrared 720P Side Mount CCTV Camera

 Durite 12 Volts DC infrared 720P side-mounted CCTV camera with audio.

• Durite 720P AHD 1/3 inch Sony CMOS camera supports both normal and mirror images.
• Automatic gain control (AGC).
• 150 degrees view angle
• Waterproof to IP69K
• E Marked R10 EMC approved

Warnings

• Before using this unit, please read these instructions carefully.
• Take special care to follow the warnings and safety suggestions listed below. Keep these instructions for future reference.
• There are no user-serviceable parts within the unit; refer servicing to qualified service personnel.

Precautions

• Please ensure you are familiar with and comply with local traffic and driving regulations.
• Connection - The camera should only be connected to a Durite CCTV system.
• Heat - Do not install the camera near heat sources.
• Mounting - Ensure the camera is facing the desired direction before fixing the camera base. If fixing to isolated return chassis, the camera bracket should be isolated from the vehicle chassis.
• Service - The user should not attempt to service these units beyond those described in these instructions. All other servicing should be referred to an authorised service technician.
• Fixture - Do not over-tighten the camera housing/cover to base plate screws. The recommended torque setting for tightening is 0.45-0.55Nm.

General

• The camera has a CMOS image sensor, which gives a high-quality picture, and its solid-state circuitry provides an extremely long life. The compact size and single connection make it easy to install.
• Automatic gain control (AGC) provides a clear image in both strong sunlight and low light conditions; if lighting conditions fall below a set level, the Infrared LEDs will illuminate.
• It is recommended that all camera lead connections are additionally sealed by either wrapping with a suitable tape or applying heat shrink sleeving.
• It is recommended to connect the system and test before fixing it to ensure the correct field of view is displayed.

Mirror vs Normal Image

• The cameras default image is a MIRROR image.
• There is a jumper included with the camera.
• If NORMAL image viewing is required, please connect the jumper to the applicable connection on the camera flying lead.
• Disconnect and then reconnect the power to the camera for the setting change to take place.

Specifications