0-525-36 Durite Marine 12V-24V LED Illuminated Oil Pressure Gauge

 Durite marine-styled 12V-24V LED illuminated oil pressure gauge. Supplied with 1/8 inch - 27 NPT sender.

• 90-degree sweep dial, 0-10 Bar.
• Plastic cased.
• LED illumination choice of White or Yellow
• Matt black bezel and white figures.
• Requires 52mm dashboard hole.
• Large screw collar type fitting.

Associated Products

• 0-523-89 Replacement sender.
• 0-525-86 Durite marine oil pressure sender unit 0-10Bar.

Wiring Gauge

1. Black – to Common Ground (-)
2. Red – to Positive (+)
3. Green – to the sensor unit
4. White – for the White backlight (+)
5. Orange – for the Yellow backlight (+)

Wiring Sender

1. W.L./G to Common Ground (-)
2. S - to gauge

Fitting Instructions

1. Cut a 52mm (2 1/16 inch) diameter panel hole.
2. Save a minimum of 55mm (2 3/16 inches) depth behind the panel to fit the gauge.
3. Remove the fastening ring.
4. Fit cables through the panel hole and insert the connector into the back of the gauge.
5. Insert the gauge through the panel from the front, fit and tighten the fastening ring from the rear, checking the gauge's position before tightening.
6. Connect cables by following the instructions.

Specifications