0-441-65 Durite R10 High Intensity 6 Amber & Red LED Warning Light

Durite 12V-24Vdc R10 high intensity 6 Amber and Red LED warning light (19 flash patterns).

• 6 x 0.5W LEDs
• 19 flash patterns
• 200mm flying leads
• 3W power
• Protected to IP67

Dimensions

• Length: 112.6mm
• Width: 28.3mm
• Height: 12.6mm

19 Flash Patterns Total

 Random, single (split), double (split), quad (split), quint (split), mega (split), ultra (split), single-quad (split), single H/L (split), single (all), double (all), quad (all), quint (all), mega (all), ultra (all), single-quad (all), single H/L (all), steady 2 (California), steady 4 (all).

Mounting

1. Place the unit against the mounting surface.
2. Mark the areas where the mounting holes are to be drilled. Confirm that no vehicle parts could be damaged by the drilling process.
3. Using a bit size for a no. 304 metal screw, drill two mounting holes, a 0.5-inch diameter. Wire passage hole(s) must also be drilled. Thoroughly de-burr all hole(s).
4. Pass the wires through the hole(s) in the gasket and through the wire passage hole(s) in the mounting surface. Fix the light head to the mounting surface.

Wiring Colours

• RED: to +Vdc (fuse @ 3A)
• BLACK: to chassis - ground.
• YELLOW: for synchronization
• GREEN: for asynchronization

Specifications

Warnings

 Before using this unit, please read these instructions carefully. Take special care to follow the warnings and safety suggestions listed below. Keep these instructions for future reference.

Safety Warnings For Translation

1. Proper installation of this product requires the installer to understand automotive electronics, systems and procedures well.
2. If mounting this product requires drilling holes, the installer MUST be sure that no vehicle components or other vital parts could be damaged by the drilling process. Check both sides of the mounting surface before drilling begins. Also, de-burr the holes and remove any metal shards or remnants.
3. Do not install this product or route any wires in the deployment area of your airbag. Equipment mounted or located in the airbag deployment area will damage or reduce the airbag's effectiveness or become a projectile that could cause severe personal injury or death. Refer to your vehicle owner's manual for the airbag deployment area. The User/Installer assumes full responsibility for determining the proper mounting location based on providing ultimate safety to all passengers inside the vehicle.
4. Do not attempt to activate or control this device in a hazardous driving situation.
5. This product contains high-intensity LEDs. Do not stare directly into these lights. Momentary blindness and eye damage could result.
6. Use only soap and water to clean the outer lens. The use of other chemicals could result in premature lens cracking (crazing) and discolouration. Lenses in this condition have significantly reduced effectiveness. Inspect and operate this product regularly to confirm its proper operation and mounting condition. Do not use a pressure washer to clean this product.
7. It is recommended that these instructions be stored in a safe place and referred to when performing maintenance and reinstallation of this product.
8. A good electrical connection to the chassis ground must be made for this product to operate at optimum efficiency. The recommended procedure requires the product ground wire to be connected directly to the NEGATIVE (-) battery post.