0-099-11 Durite 12Vdc IP68 Ford Transit LED Brake Light Camera

 Durite 12V brake light camera for Ford transit 2007-2023 vans.

• Compact and easy to fit, simply replace existing brake light camera no drilling required.
• 1/3 inch Sony CCD camera.
• Automatic gain control and night vision distance up to 35ft.
• Default mirror image, ideal for use when reversing.
• Comes with a 10M lead.
• Protected to IP68.

Dimensions

• Length: 136.5mm
• Width: 387.5mm
• Depth: 59.5mm

Warnings

• Before using this unit please read these instructions carefully.
• Take special care to follow the warnings and safety suggestions listed below.
• Keep these instructions for future reference.
• There are no user-serviceable parts within the unit, refer servicing to qualified service personnel.

Precautions

• Please ensure you are familiar with and comply with local traffic and driving regulations.
• Connection - The camera should only be connected to a Durite CCTV system.
• Heat - Do not install the camera near heat sources.
• Mounting - Ensure the camera is facing the desired direction before fixing the camera base. If fixing to isolated return chassis the camera bracket should be isolated from the vehicle chassis.
• Service - The user should not attempt to service these units beyond those described in these instructions. All other servicing should be referred to an authorised service technician.

General

• The camera has a CCD image sensor which gives a high-quality picture and its solid-state circuitry provides extremely long life.
• Compact size and single connection make it easy to install.
• Automatic gain control (AGC) provides a clear image in both strong sunlight and low light conditions, if lighting conditions fall below a set level the Infrared LEDs will illuminate.
• It is recommended that all camera lead connections are additionally sealed by either wrapping with a suitable tape or application of heat shrink sleeving.
• It is recommended to connect the system and test before fixing to ensure the correct field of view is displayed.

Image Viewing - Normal Vs. Mirror

• The default image is set to MIRROR Image Mode for reversing.
• To change to NORMAL Image please refer to guidelines in your CCTV Manual in the Monitor Control section.

Specifications